Prop Balancer


This is a single piece prop balancer, that can fit up to 10" props spinning all the way around. I wanted a one piece design for alignment and accuracy at the expense of portability/storage space.

For use with:

(or any other figertip balancer with the same axle length, approximately 1.92in/48.8mm)

Also need 1/4 in magnets, I had these sitting around:

Prop Balancer by noishi is licensed under the Creative Commons - Attribution - Share Alike license.

Single File Downloads

Name Type
STL FILE Prop_Balancer Prop_Balancer.STL
0.00 KB
STL Download
  • 3510uploads
  • 0questions
  • 0answers