Kyosho Mini-Z MR-02/MR-03 Wheels (0 offset)


Just a quick try to make usable wheels for Kyosho Mini-Z RC car, these are for MR-02 or MR-03 models, will not fit on AWD. Standard wheels with 0 offset, front and rear wheel. Do note this is a work in progress as it needs a little bit of fine tuning on the inside where you place plastic bushings or bearings. You need to print with finer resolution such as 0.1mm for best results and use support material for the inside to print well.

Designed by

Kyosho Mini-Z MR-02/MR-03 Wheels (0 offset) by 3dprintingblog is licensed under the Creative Commons - Attribution - Non-Commercial license.

Single File Downloads

Name Type
STL FILE rwd-front-tire rwd-front-tire.stl
0.00 KB
STL Download
STL FILE rwd-rear-tire rwd-rear-tire.stl
0.00 KB
STL Download
  • 3510uploads
  • 0questions
  • 0answers