Clip-on bracket and mounting box


Description

Adapted from Box with Latching System NEW
(http://www.thingiverse.com/thing:69518), I needed a clip-on system that joind between two pieces, rather than on the same side of two pieces, as in the original.

The clip works, though there's some play. The smaller piece, "bracket outer", is quite small, about 10 mm wide. The asymmetry in the other piece, "bracket inner", avoids overhangs when printing.

Clip-on bracket and mounting box by hedonistica is licensed under the Creative Commons - Attribution - Share Alike license.

Single File Downloads

Name Type
STL FILE bracket_inner_nooverhang(1) bracket_inner_nooverhang(1).stl
214.74 KB
STL Download
STL FILE bracket_inner_nooverhang bracket_inner_nooverhang.stl
214.74 KB
STL Download
STL FILE bracket_outer bracket_outer.stl
176.38 KB
STL Download
Elsita
  • 3510uploads
  • 0questions
  • 0answers

Fileinfo